TruCut Sanding Pads - 6" Singles: 2000
Product information "TruCut Sanding Pads - 6" Singles: 2000"
The new TruCut by CtD pads are specifically designed for bowling balls. These pads provide a longer lasting, true cut that resists "lane shine" and improves ball durability and performance.
Comparison of close-up images of a TruCut by CtD and an Abralon pad:
Available in the following grits:
- 80, 120, 220/240
- 500, 1000, 1500, 2000, 3000, 4000, P5000D (4000 by hand, 5000 on a ball spinner)
Advantages:
- longer lasting
- brings the surface to the specified grit number
- reusable and easy to clean
- easier to use when dry or wet sanding
- Open honeycomb structure
For small changes before or after play:
Apply the pad to the surface of the bowling ball with moderate pressure using small circles. Move around the sides of the ball first and then upward. Repeat twice to work the entire half of the bowling ball. Then turn it over and repeat the process on the other half. Apply a little That Purple Stuff to a CtD Power Pad and wipe the dust off the bowling ball.
For use on a ball spinner:
Spray TruCut Sanding Pad with TruCut Conditioner. Turn the spinner on low speed and apply the pad to the surface of the bowling ball with moderate pressure. Move the pad back and forth from the top of the ball to the sides of the ball for 5 seconds. Turn the ball over and repeat on all 4 sides for even results.
IMPORTANT NOTICE:
Write the grit numbers on the back of the pads with a permanent marker..
Cleaning Instructions:
For dry use - tap the pad on a hard surface to get the dust out.
For wet use - hold the pad under running water and flatten. DO NOT CRUMPLE.
Login